Filter
Top Products
PARTIAL COPYING
The Partial Copy function copies only a part of an original.
This function specifies the start and end points in the original feed direction.
S The Partial Copy function cannot apply to originals having a length of less
than 245 mm, 9.6" in the paper feed direction.
S The Partial Copy function cannot be used in the rear table.
S The Partial Copy function cannot be used when the Sample Copy function
is selected.
S The start and end points cannot be set within 162 mm, 6.4" from the leading
edge of paper.
S The spacing between the start and end points is 100 mm, 4.0" at the
minimum.
S Roll paper is cut in 250 mm, 9.9" at the minimum.
1
Press the Partial Copy key.
The indicator on the Partial Copy
key blinks.
✏ When you press the Partial
Copy key again, the leading
edge of an original becomes
the start point for partial
copying. When you press the
Partial Copy key for the third
time, you can cancel partial
copying.
2
Set your original.
The copier starts copying.
✏ Do not release the original
until it is fed into the copier.
COPYING 19