Filter
Top Products
FUNCTIONS THAT CAN BE RESET
You can make the copier easier to use by resetting some functions to meet your
copying needs. When you want to reset a function, contact your service
representative.
You can reset the following functions:
Changing the Auto Reset time
The copier resets itself to the initial settings if it is idle for about 2 minutes during
or after copying. This is called "Auto Reset". The auto reset time can be set
from 1 to 5 minutes, or it can be turned off.
Copy count up or down
When copying starts, the indicator shows 1 and increments by one each time a
copy is made until copying ends. This display can be changed so that it
decrements by one (from the set number of copies) to show the number of
remaining copies.
Beeper on/off
The beeper heard when the keys are pressed can be disabled.
Disabling the "Auto Image Density" function
By default, the "Auto Image Density" function is used when the copier is turned
on. If originals that are not suitable for automatic density adjustment are often
copied, the "Auto Image Density" function can be disabled.
Enabling the "lower copy exit"
By default, the "upper copy exit" is selected when the copier is turned on. If
paper that is not suitable for the upper copy exit (e.g., A0, 36"
× 48" K/ A1, 24"
× 26" K) is often used, the "lower copy exit" can be enabled.
Enabling the frequently used paper selection
The frequently used paper selection can be enabled to omit the paper selecting
operation when the copier is turned on.
Changing the "Auto Image Density"
If copies consistently come out too dark or too light even when the "Auto Image
Density" function is selected, the target density of this function can be changed.
48 MAINTAINING YOUR COPIER