Filter
Top Products
Getting Started
3 - 3
3.2 Incoming Logins
Incoming logins made via EZWebCon can be used to configure the server. Incoming LAT and
TCP/IP logins can also be used.
Incoming Telnet is enabled by default to allow TCP/IP connections. To change this setting, use
the Define Server Incoming command described in the Command Reference chapter of the Print
Server Reference Manual located on CD-ROM.
Incoming logins do not prompt for a login password; therefore, you may wish to disable them. If
it is undesirable to disable incoming logins, the Server can be configured to prompt for a
password with the Define Server Incoming Password Enabled command.
3.3 Services
With few exceptions, a service must be created before print queues can be configured on the EPS.
A service is a resource accessible to network hosts. A Lantronix service is also known as a remote
printer name or remote queue name on many operating systems.
The EPS
offers a default service on each port. The service names are EPS_xxxxxx_yy where
xxxxxx represents the last six numbers of the unit’s Ethernet address and yy is the port name, for
example EPS_xxxxxx_S1 (serial port) or EPS_xxxxxx_P1 (parallel port).
NOTE: The default service names are based on the server name; therefore the
server name must be no more than 13 characters.