Filter
Top Products
UDS10/UDS100 User Guide Getting Started
15
Required Information
Before configuring the UDS, have the following information available:
Hardware Address
Take note of the unit’s hardware address (also known as the Ethernet or MAC
address). It is on the product label, in the format: 00-20-4a-XX-XX-XX, where the XXs
are unique numbers assigned to the product (see Product Information Label on
page13).
Hardware Address: 00-20-4a-_____-_____-_____
IP Address
The UDS must have a unique IP address on your network. This address references
the specific unit. By default, the device is DHCP-enabled and automatically assigned
an IP address on DHCP-enabled networks. If you are assigning a static IP address,
the systems administrator generally provides the IP address, subnet mask, and
gateway.
Note: The factory default IP address is 0.0.0.0 to enable DHCP, BOOTP,
and AutoIP. When the units boots, it sends a DHCP broadcast to try and get
an IP address. If it receives no reply from a DHCP server, the UDS tries
BOOTP. If the UDS does not receive a response from BOOTP, it reverts to
an AutoIP address.
IP Address: _______ _______ _______ _______
Subnet Mask: ___
____ _______ _______ _______
Gateway: _______ _______ _______ _______
You have several options for assigning an IP to your unit. This chapter provides
information about using the DeviceInstaller (graphical user interface) and serial port
login (command line interface) methods.
Note: For information about other methods of assigning the IP address,
such as DHCP, AutoIP, ARP, and Telnet, see A: Alternative Ways to Assign
an IP Address.