Filter
Top Products
Configuring the UDS Using Telnet or the Serial Port UDS10/UDS100 User Guide
30
Figure 5-6. Hostlist Option
To use the hostlist option, follow these steps:
1. To enable the hostlist, enter a Connect Mode of 0x20 (2X). The menu shows you
a list of current entries already defined in the product.
2. To delete, modify, or add an entry, select Yes. If you enter an IP address of
0.0.0.0, that entry and all others after it are deleted.
3. After completing the hostlist, repeat the previous step if necessary to edit the
hostlist again.
4. For Retrycounter, enter the number of times the Lantronix unit should try to
make a good network connection to a hostlist entry that it has successfully
ARPed.
5. For Retrytimeout, enter the number of seconds the unit should wait before
failing an attempted connection.
Modem (Emulation) Mode: In Modem Mode, the unit presents a modem interface
to the attached serial device. It accepts AT-style modem commands, and handles the
modem signals correctly.
Normally there is a modem connected to a local PC and a modem connected to a
remote machine. A user must dial from the local PC to the remote machine,