Filter
Top Products
Configuring the UDS Using Telnet or the Serial Port UDS10/UDS100 User Guide
24
2. Type three lowercase x characters (xxx) within one second after powering up
to start the configuration mode.
Note: The easiest way to enter Setup Mode is to hold down the x key on
your keyboard while powering up the unit.
The configuration settings display, followed by the Change Setup menu.
3. Select an option on the menu by entering the number of the option in the Your
choice ? prompt and pressing Enter.
4. To enter a value for a parameter, type the value and press Enter. To confirm a
default value, just press Enter.
5. When you are finished, save the new configuration (option 9). The unit reboots.
Server Configuration (Network Configuration)
Type 0 in the Your choice ? prompt and press Enter. Current values display in
parentheses. The following sections describe the configurable settings within the
Server configuration menu.
Figure 5-3. Network Configuration
IP Address
The IP address must be set to a unique value in your network. If the IP address has
not been assigned by DHCP, enter it manually. Enter each octet, pressing Enter after
each. See A: Alternative Ways to Assign an IP Address for more information about IP
addressing.
Set Gateway IP Address
The gateway address, or router, allows communication to other LAN segments. The
gateway address should be the IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within the local network.
Netmask
A netmask defines the number of bits taken from the IP address that are assigned for
the host section. The host section is the part of the IP address that is specific to the
UDS.