Filter
Top Products
SUPPLIER’S DECLARATION OF CONFORMITY
Place of Issue: St. Charles, IL
Date of Issue: August 17, 2001
Dukane Corporation, located at 2900 Dukane Drive, St. Charles, IL 60174 in the United
States of America, hereby certifies that Master Clock model 24A715M bearing labeling
identification number US:A95DT06B24A715M complies with the Federal Communica
-
tions Commission’s (“FCC”) Rules and Regulations 47 CFR Part 68, and the
Administrative Council on Terminal Attachments (“ACTA”)—adopted technical criteria:
TIA/EIA/IS-968, Telecommunications—Telephone Terminal Equipment—Technical Re
-
quirements for Connection of Terminal Equipment to the Telephone Network, July 2001.
Rolf Goehler
Rolf Goehler
General Manager, Communications Systems Division
NOTICE: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective, opera-
tional and safety requirements. The Industry Canada does not guarantee the equipment
will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be con-
nected to the facilities of the local Telecommunications Company. This equipment must
also be installed using an acceptable method of connection. In some cases, the company’s
inside wiring associated with a single line individual service may be extended by means
of a certified connector assembly (telephone extension cord). The customer should be
aware that compliance with the above conditions may not prevent degradation of service
in some situations.
Any equipment repairs made by the user, or equipment malfunctions, may give the Tele
-
communications Company cause to request the user to disconnect the equipment.
Users should ensure, for their own protection, that the electrical ground connections of
the power utility, telephone lines, and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority or electrician, as appropriate.
NOTE: The Ringer Equivalence Number (REN) assigned to each terminal device pro
-
vides an indication of the maximum number of terminals allowed to be connected to a
telephone interface. The termination of an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalence Numbers
of all the devices does not exceed five (5).