Filter
Top Products
Note: You might need to disconnect power cables for other hard disk drives installed in your computer
and then rotate the air ow wall outward for easier access to the rear of the new hard disk drive.
Figure 22. Rotating the air ow wall
10. Connect the other end of the signal cable to one of the available hard disk drive connectors on the
system board. See “Locating parts and connectors on the system board” on page 9.
11. Reconnect all hard disk drive power cables that you have removed and then rotate the air ow wall
inward into the computer.
12. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 14.
13. Reinstall the PCI card holder. See “Removing and reinstalling the PCI card holder” on page 15.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 37.
Replacing a hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the ThinkStation Safety and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide, go to:
http://support.lenovo.com
This section provides instructions on how to replace a hard disk drive.
To replace a hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
26 ThinkStation User Guide