Filter
Top Products
1 Operator information panel connector
2 Operator information panel cable
4. Install the cover (see “Removing and replacing the cover” on page 43).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that were removed.
7. Turn on the peripheral devices and the server.
Removing and installing the system board
To remove and install the system board, complete the steps in this section.
Removing the system board
To remove the system board, complete the following steps.
Notes:
1. When you replace the system board, make sure that you remove IMM Premium
and place it on the new system board. For information about the location of the
key, see “System-board optional-device connectors” on page 29.
2. When you replace the system board, you must either update the server with the
latest firmware or restore the pre-existing firmware that the customer provides
on a diskette or CD image. Make sure that you have the latest firmware or a
copy of the pre-existing firmware before you proceed.
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords;
then, remove the cover (see “Removing and replacing the cover” on page 43).
Note:
When you replace the system board, you must either update the server
with the latest firmware or restore the pre-existing firmware that the customer
Chapter 5. Installing optional devices and replacing customer replaceable units 91