Filter
Top Products
12. Lift up the system board and carefully remove it from the server, being careful
not to damage any surrounding components.
13. If you are instructed to return the system board, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the system board
Notes:
1. When reassembling the components in the server, be sure to route all cables
carefully so that they are not exposed to excessive pressure.
2. When you replace the system board, you must either update the server with the
latest firmware or restore the pre-existing firmware that the customer provides
on a diskette or CD image.
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code
To install the system board, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Grasp the fan assembly brackets and rotate them down toward the chassis.
3. Grasp the fan assembly brackets and rotate them down toward the chassis.
4. Reinstall the hot-swap fans (see “Removing and installing a hot-swap fan
assembly” on page 79).
5. Reinstall the microprocessor and heat sink.
6. Reinstall the SAS/SATA RAID riser-card assembly base (see “Removing and
installing the SAS/SATA RAID riser-card assembly” on page 82).
Chapter 5. Installing optional devices and replacing customer replaceable units 93