Filter
Top Products
4. Reinstall the flash device, if it was removed.
5. Align the SAS/SATA RAID riser-card assembly keys correctly with the
connector on the system board and press down on the assembly until it is
seated firmly into the connector on the system board.
6. Connect the signal cables to the SAS/SATA adapter.
7. Install the cover.
8. Slide the server into the rack.
9. Reconnect the power cord and any cables that you removed.
10. Turn on the peripheral devices and the server.
Removing and installing the battery
To remove and install the battery, complete the steps in this section.
Removing the battery
To remove the system-board battery, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing and replacing the cover” on page 43).
3. If necessary, lift the riser-card assembly out of the way (see “Removing and
installing a PCI riser-card assembly” on page 53).
4. Locate the battery 1 on the system board.
Chapter 5. Installing optional devices and replacing customer replaceable units 83