Filter
Top Products
54
6.3 Setup Printer server’s IP Address
The printer server must have a unique IP address in order to be
recognized by the network.
You can set up the IP address on the various Unix systems using
any one of the following methods:
1. DHCP (Dynamic Host Configuration Protocol)
2. BOOTP (Bootstrap Protocol)
The printer server will use the last three methods to obtain its IP
address automatically if its IP address is configured as Auto (0.0.0.0).
6.3.1 DHCP
There are many Unix systems that support DHCP protocol, and the
procedures to configure the DHCP server database are different. This
manual does not describe the DHCP server configuration on the Unix
systems. It is highly recommended that the DHCP server should be
located on the same network as the printer server.
6.3.2 BOOTP
If you have the BOOTP daemon, bootpd, running on your UNIX
system that is accessible by the printer server, you can use the BOOTP
protocol to set up the IP address of the printer server. We recommend
that the BOOTP server should be located on the same subnet as the
printer server. If you use Network Information Services (NIS) in your
system, you may need to rebuild the NIS map with the BOOTP services
before doing the following BOOTP configuration. To rebuild the NIS map,
please refer to your system documentation.
To configure the IP address data for the BOOTP server, you will
need to log in the host of BOOTP server as the superuser (root). Perform
the following steps to add address entries,
1. Optionally, assign a name corresponding to the printer server’s
IP address. You can add this address to the /etc/hosts file, by adding a
line such as:
203.66.191.12 pserver