Filter
Top Products
Introduction
Connections - WBR-1100TX
Figure 2: Connections - WBR-1100TX
Printer Port
A standard parallel printer port is on the side panel. If you wish to
share a printer, connect it here.
Serial (RS232)
Port
A standard RS232 Serial Port is on the side panel. If you have an
analog modem or ISDN TA, connect it here.
WAN port
(10BaseT)
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
DIP switches
Refer to the following table.
PC port
(10/100BaseT)
If connecting directly to your PC (no Hub) use this port and a stan-
dard LAN cable (RJ45 connectors).
Use EITHER the PC port OR the Hub port, NOT both.
HUB port
(10/100BaseT)
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub.
Use EITHER the PC port OR the Hub port, NOT both.
Reset Button
This button has three (3) functions:
• Reboot. When pressed and released, the LevelOne Wireless
Broadband Router will reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the diag-
nostic printing.
• Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The LevelOne Wireless Broadband
Router is now using the factory default values.
7