LevelOne WBR-1100TX Network Router User Manual


 
LevelOne Wireless Broadband Router User Guide
Data - Dial-in Users Screen
Modem
Modem
If using a permanent connection or leased line, select "Perma-
nent Connection (leased line)".
If your modem or ISDN TA is in the drop-down list, just select
it.
If your modem is not in the list, select the appropriate "Stan-
dard Modem" entry and test to see if this works.
If the "Standard Modem" selection does not work, select "User-
defined", then click the Modem Properties button to configure
the modem correctly.
Modem Properties
Button
This button is only operational for the "User-defined" modem
type.
Click this button to open the Modem Properties screen and
allow changing of the modem's properties. See Modem Proper-
ties Screen later in this Chapter for details.
Serial Line Speed
Select the speed which is equal to or below the fastest SERIAL line
speed (NOT phone line speed) of your modem. Available speeds
range from 4.8K to 460.8K (bps).
Dial-in Settings
Enable Dial-in
If checked, the serial port is available for dial-in access. Other-
wise, any attempt to dial-in will be blocked.
If Internet Access is also enabled, Dial-in users may find it
difficult to connect because the telephone line is in use. Reduc-
ing the Disconnect after Idle Time-out setting for Internet
Access to 1 minute may help.
Only authorized users can use the Dial-in connection.
See the Dial-in section of the User Manual for details on setting
up the remote PC to use the Dial-in facility.
Disconnect after
Idle Time
If checked, the Dial-in connection will be terminated after
being idle for the time specified.
If not checked, the Dial-in connection will never be terminated.
72