Filter
Top Products
Introduction
Connections - WBR-1400TX
Figure 3: Connections - WBR-1400TX
Printer Port
A standard parallel printer port is on the side panel. If you wish to share a
printer, connect it here.
PCMCIA slot
Insert the supplied Wireless PCMCIA card into this slot.
• Ensure the power is OFF before inserting or removing the
PCMCIA Card.
• Do not use any other PCMCIA Card.
Reset Button
This button has three (3) functions:
• Reboot. When pressed and released, the LevelOne Wireless Broad-
band Router will reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the diagnostic
printing.
• Clear All Data. This button can also be used to clear ALL data and
restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
7. Power Off.
8. Hold the Reset Button down while you Power On.
9. Keep holding the Reset Button for a few seconds, until the RED
Status LED has flashed TWICE.
10. Release the Reset Button. The LevelOne Wireless Broadband Router
is now using the factory default values.
WAN port
(10BaseT)
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
10/100BaseT
LAN ports
(Hub ports)
Use standard LAN cables (RJ45 connectors) to connect your PCs to these
switching hub ports. Both 10BaseT and 100BaseT connections can be
used simultaneously.
Note:
Any LAN port on the LevelOne WBR-1400TX will automatically
function as an "Uplink" port when required. Just connect any port to a
normal port on the other hub, using a standard LAN cable.
Power port
Connect the supplied power adapter here.
9