Filter
Top Products
Adjusting Power Saver
80
Administrative support
Adjusting Power Saver
To adjust the Power Saver setting:
1 Make sure the printer is on and Ready appears on the display.
2 Press on the operator panel.
3 Press until Settings appears, and then press .
4 Press until Setup Menu appears, and then press .
5 Press until Power Saver appears, and then press .
6 Using the right and left arrows on the operator panel, enter the number of minutes for the printer to wait before
entering Power Saver.
The settings available range from 1–240 minutes.
7 Press .
Submitting Selection appears.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command. For
more information, see the Technical Reference available on the Lexmark Web site at
www.lexmark.com/publications.
Encrypting the disk
Warning: All resources on the hard disk and RAM will be deleted.
Note: This setting is only available when a hard disk is installed.
1 Turn the printer off.
2 Press and hold and while turning the printer on.
3 Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4 Press until Disk Encryption appears, and then press .
5 Press until Enable appears, and then press .
Contents will be lost. Continue? appears.
6 Press until Yes appears, and then press .
The Encrypting Disk progress bar appears.
7 When disk encryption has finished, press .
8 Press until Exit Config Menu appears, and then press .
To disable disk encryption:
1 Turn the printer off.
2 Press and hold and while turning the printer on.
3 Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4 Press until Disk Encryption appears, and then press .