Lexmark MX710DE Printer User Manual


 
Use To
Web Page Refresh Rate
30–300
Specify the number of seconds between Embedded Web Server
refreshes.
Note: 120 is the factory default setting.
Contact Name Specify a contact name for the printer.
Note: The contact name is stored on the Embedded Web Server.
Location Specify the location of the printer.
Note: The location is stored on the Embedded Web Server.
Alarms
Alarm Control
Cartridge Alarm
Set an alarm to sound when the printer requires operator
intervention.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
Single is the factory default setting for Alarm Control. This
sounds three quick beeps.
Off is the factory default setting for Cartridge Alarm. This
means no alarm will sound.
Continuous repeats three beeps every 10 seconds.
Timeouts
Standby Mode
Disabled
1–240
Specify the number of minutes of inactivity before the printer
enters a lower power state.
Note: 15 is the factory default setting.
Timeouts
Sleep Mode
Disabled
1180
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
30 is the factory default setting.
Lower settings conserve more energy, but may require
longer warmup times.
Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warmup time.
Understanding the printer menus 188