Linksys BEPSR41 Network Router User Manual


 
EtherFast
®
Cable/DSL Routers
43
Instant Broadband
Series
42
3. The Router configuration screen will appear with the Setup tab selected.
Based on the setup instructions from your ISP, you may need to provide the
following information.
Host Name and Domain Name: These fields allow you to provide a host
name and domain name for the Router. These fields are usually left blank.
If requested by your ISP (usually cable ISPs), complete these two fields.
Device IP Address and Subnet Mask: The values for the Router’s IP
Address and Subnet Mask are shown on the Setup screen. The default value
is 192.168.1.1 for the IP Address and 255.255.255.0 for the Subnet Mask.
Leave these settings alone.
4. The Router supports five connection types: DHCP (obtain an IP automati-
cally), PPPoE, Static IP Address, RAS, and PPTP. These types are listed in
the drop-down menu for the WAN Connection Type setting. Each Setup
screen and available features will differ depending on what kind of connec-
tion type you select. Proceed to the instructions for the connection type you
are using. When you are finished with the Setup tab, proceed to step 5.
IMPORTANT: If you have previously enabled any Internet-sharing
proxy server software on any of your PCs, you must disable it now.
Some examples of Internet-sharing software are Internet LanBridge,
Wingate, ICS, and Sygate. To disable your Internet-sharing software:
• If you are running Netscape Navigator, click Edit >> Preferences
>> Advanced >> Proxies. Click Direct Connection to the
Internet.
• If you are running Internet Explorer 5.x or higher, click Start >>
Settings >> Control Panel >> Internet Options >> Connections
>> LAN Settings. Remove checkmarks from all three boxes. Click
the OK button to continue.
Also, you must disable any Internet log-on software (such as Ivasion
Winpoet or Enternet 300) and any firewall software (such as
ZoneAlarm and Watchdog) on all of your PCs.
Chapter 8: Configure the Router
This chapter will show you how to configure the Router to function in your net-
work and gain access to the Internet through your Internet Service Provider
(ISP). Detailed description of the Router’s Web-based Utility can be found in
“Chapter 9: The Cable/DSL Router’s Web-based Utility.” Your ISP may require
the use of a Host Name and Domain Name. Further, you will set the WAN
Connection Type on the Router’s Setup tab based on the information provided
by your ISP. You will need the setup information from your ISP. If you do not
have this information, please contact your ISP before proceeding.
The instructions from your ISP tell you how to set up your PC for Internet
access. Because you are now using the Router to share Internet access among
several computers, you will use the setup information to configure the Router
instead of your PC. You only need to configure the Router once using the first
computer you set up.
1. Open your web browser. (It is all right if you get an error message at this
point. Continue following these directions.) Enter http://192.168.1.1 in the
web browser’s Address field,
as shown in Figure 8-1, and
press the Enter key.
2. An Enter Network Password window, shown in Figure 8-2, will appear
(Windows XP users will see a Connect to 192.168.1.1 window, shown in
Figure 8-3). Leave the User Name field empty, and enter admin in lower-
case letters in the Password field (admin is the default password). Then,
click the OK button.
Figure 8-1
Figure 8-2 Figure 8-3