Filter
Top Products
10/100 Managed 24-Port GigaSwitch
11. Type an IP address for trap host 1. The address consists of numbers
separated by periods (e.g., 129.32.0.11).
12. Press Enter. The IP address you typed will appear next to Trap Host 1
IP Address.
13. To specify up to two additional trap community names, repeat steps 10
through 12.
14. To change the cold start trap setting, press the Down Arrow key to move
to Cold Start Trap and press Enter. The Trap Options screen will appear.
15. Select Disabled or Enabled and press Enter. Your selection will appear
next to Cold Start Trap.
16. Press the Down Arrow key to move to Warm Start Trap and press the
Enter key. The Trap Options screen will appear.
67
Linksys EtherFast
®
II Series
4. Type a get community name and press Enter. The get community name
you typed will appear next to Get Community Name.
5. Use the Down Arrow key to move to Set Community Name and press
Enter. The Enter Set Community Name screen will appear.
6. Type a set community name and press Enter. The set community name
you typed will appear next to Set Community Name.
7. Use the Down Arrow key to move to Trap Community Name and press
Enter. The Enter Trap Community Name screen will appear.
8. Type a trap community name and press Enter. The set community name
you typed will appear next to Trap Community Name.
9. To specify up to three additional trap community names, repeat steps 7 and 8.
10. To specify a trap host IP address, use the Down Arrow key to move to
Trap Host 1 IP Address and press Enter. The Enter Trap Host 1 IP
Address screen will appear (see next page).
66