Filter
Top Products
60 INSTALLERS MANUAL | Copyright © 2006 Digimerge Technologies Inc.
Connecting Motion / Alarm Device
APPENDIX 2
Connecting Motion / Alarm Device
Motion detection and Alarm controls are enabled through the Menu system on the DVR.
Additional motion sensor devices can be connected to the system (Motion Sensors, Door/
Window Sensors).
DVR
SENSOR
(Not Included)
A motion detection or sensor unit can
be used to send a signal to the DVR
to begin camera recording on the
selected Video Channel (when
enabled in the Alarm Recording
Menu)
• Example: A Window sensor unit
has been installed on Alarm
Block port #4. When this sensor
is activated, the camera on port
#4 will start recording (if enabled
in the MENU on the DVR)
For the corresponding Menu Pro-
gramming, refer to Page 30.
Installing a Sensor
1. Connect the GROUND Cable to the
GND port on the Alarm Block on the
DVR
2. Connect the SIGNAL Cable to a
numbered port (1-4)
To start ALARM RECORDING on a
DVR, refer to the RECORDING SET
section of the manual.
1
2