Filter
Top Products
SP Switch Router Adapter Guide - 1.4 Update 2
October 25, 1999
xiii
About this Guide
Lucent’s GRF switched IP routers can be used to provide high-speed data communication links
between IBM RS/6000 Scalable POWERparallel Systems (SP) and external networks/hosts.
When packaged with an IBM SP system, the GRF router is referred to as an RS/6000 SP
Switch Router, or SP Switch Router. The SP Switch Router Adapter card is the GRF media
card that specifically supports SP system data transfers. To connect to an SP system, the SP
Switch Router Adapter card is cabled directly to an SP Switch port.
The
SP Switch Router Adapter Guide
describes the media card itself and explains how to
install, verify, and configure the card. The
Guide
provides the same type of information for this
media card as is provided for other GRF media cards. Information specific to installing and
configuring a GRF router is found in the manuals listed below in the “Manual sets” section.
The RS/6000 SP Switch Router is based on the GRF 400 and GRF1600 routers manufactured
by Lucent Technologies. For that reason, this manual contains references to the
GRF 400/1600 Getting Started
,
GRF Reference Guide
, and
GRF Configuration and
Management
manuals.
About 1.4 Update 2
The GRF 1.4 Update 2 manual set includes new features added since software release 1.4.12.
GateD information is provided in a separate document, the
GRF GateD Manual.
How to use this Guide
The
Guide
contains the following chapters and an index:
• Chapter 1, “Introduction to the SP Switch Router Adapter Card,” describes the SP Switch
Router Adapter media card, its cables, LEDs, and SNMP implementation.
• Chapter 2, “Configuring the SP Switch Router Adapter,” explains how to configure the SP
Switch Router Adapter media card and how to attach it to the SP Switch.
• Chapter 3, “Monitoring and Management Tools,” contains information about commands,
logs, and dumps useful for maintaining the SP Switch Router and adapter card.
• Appendix A, “Part Numbers,” contains a table of corresponding Lucent and IBM part
numbers for SP Switch Router components.
• Appendix B, “Log Messages,” contains explanations of log messages generated by the SP
Switch Router Adapter media card.
• Appendix C, “Network Configuration Examples,” contains examples and descriptions of
three basic SP Switch network configurations and their requirements.
• Appendix D, “Upgrading SP Switch Router Software,” describes how to install new
releases of the router’s operating software.