Filter
Top Products
Introduction to the SP Switch Router Adapter card
SNMP on the SP Switch Router Adapter card
SP Switch Router Adapter Guide - 1.4 Update 2 October 22, 1999 1-15
SNMP on the SP Switch Router Adapter card
This section describes the SNMP implementation on the SP Switch Router Adapter card as a
way of providing information for staff supporting the card from the SP control workstation.
Chapter 2 describes the actual configuration procedure performed on the SP Switch Router.
Although the mib2d daemon within the SP Switch Router supports several MIBs, the SET
command is supported only for the SP Switch Router Adapter card MIB, ibmSPDepNode.
For SP Switch Router Adapter cards specifically, mib2d creates a table of
ibmSPDepNodeEntry MIB objects, one entry for each possible media card slot.
SNMP write access mode is supported for SP Switch Router Adapter configuration parameters
and for an object representing the Administrative state of the adapter.
When a SET command is received for an object defined in the ibmSPDepNode MIB, the
/etc/grdev1.conf
configuration file is also updated with the newly-set value. The SP
Switch Router Adapter card’s run-time software reports board status to mib2d.
For more information about the use of SNMP to configure the SP Switch Router Adapter card,
please refer to the “Managing Extension Nodes” chapter in the PSSP Administration Guide.
SP Switch Router Adapter dependent node MIB support
SP Switch Router Adapter MIB support complies with the dependent node MIB definition and
provides these objects:
– ibmSPDepNode
– ibmSPDepNodeTable
– ibmSPDepNodeEntry
– ibmSPDepNodeName
– ibmSPDepNodeNumber
– ibmSPDepSwToken
– ibmSPDepSwARP
– ibmSPDepSwNodeNumber
– ibmSPDepIPaddr
– ibmSPDepNetMask
– ibmSPDepIPMaxLinkPkt
– ibmSPDepIPHostOffset
– ibmSPDepConfigState
– ibmSPDepSysName
– ibmSPDepNodeState
– ibmSPDepSwChipLink
– ibmSPDepNodeDelay
– ibmSPDepAdminStatus