Filter
Top Products
26
will only send out RIP information. Selecting both means that the Lynx L-210 will incorporate
received RIP information and send out updated RIP information.
The protocol is dependent upon the entire network. Most networks support Rip v1. If RIP v1 is
selected, routing data will be sent in RIP v1 format. If Rip V2 is selected, routing data will be sent in
RIP v2 format using subnet broadcasting. If Rip V1 Compatible is selected, routing data will be sent
in RIP v2 format using multicasting.
To enable Dynamic Routing, click Advanced and under Advanced, select Dynamic Routing. Figure
18 illustrates a typical Dynamic Route.
Figure 18 (Dynamic Routing)
The apply button will temporarily save this connection. To make the change permanent you need to
click on Save Settings (at the side of the page). At the system commands page, click on Save All.
4.7 Tools
The Lynx L-210 supports a host of tools that will allow you to customize and debug your Lynx L-
210.
4.7.1 System Commands
To make the changes permanent you need to click on Tools (at the top of the page) and select
System Commands. The following commands are used to configure the gateway:
a. Save all: Press this button in order to permanently save the current configuration of the
Lynx L-210. If you do re-start the system without saving your configuration, the Lynx L-
210 will revert back to the previously saved configuration.
b. Restart: Use this button to re-start the system. If you have not saved your configurations,
the Lynx L-210 will revert back to the previously saved configuration upon re-starting.
NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.
c.
Restore Defaults: Use this button to restore factory default configuration.
NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.