Filter
Top Products
Impulse DataLogger Series 3 Instruction Manual 2/1/05
11 of 16
Introduction to DataPulse Series 3 software
DataPulse is a user friendly, Windows based, DataLogger communication
software that will allow the viewing of logger data in a spreadsheet format.
The DataPulse software functions include:
• Uploading Run, Fault, and Alarm histories and the corresponding trace
data.
• Uploading 5 sets of parameters stored in the DataLogger.
• Displaying and saving the above data.
Computer Requirements
The hardware requirements for DataPulse software:
• IBM-compatible PC with a Pentium 233 MHz or higher processor (Pentium
500 MHz or higher processor recommended)
• 64 MB RAM
• 20 MB hard disk storage
• Microsoft Windows 98se, ME, 2000, or XP
Microsoft Internet Explorer 5.5+ or higher
• USB 1.1 or 2.0 compatible port
Software Installation
The DataPulse software is designed to auto install after CD insertion, if the
installation guide does not display, then in the START menu, choose RUN. . .
and type “D:\setup.exe” where “D” is your CD drive and click “OK” or select
“BROWSE” and select setup.exe and “OK”.
After DataPulse software has finished installing, connect your DataLogger to the
computers USB port. Your PC will require you to install the driver for this “new
hardware”. The driver is located on the DataPulse CD.