Filter
Top Products
Impulse DataLogger Series 3 Instruction Manual 2/1/05
4 of 16
Logging of Run, Fault, Alarm and Trace Data
All Data collection is automatic, viewing data is per the various screens, and the
roadmap of functions per the diagram on the Menu Navigation on page 6. The
Monitor Mode of the DataLogger permits Real Time monitoring of Inverter activity.
Uploading and downloading parameter data
The drive parameters can be uploaded (stored) into the DataLogger for use at a
later time. This data, after uploading into the DataLogger, can then be used to
easily create duplicate drives during manufacturing or to create a duplicate drive in
the case of inverter failure and/or replacement. The parameter data can also be
viewed and saved to the PC using the DataPulse Series 3 PC software included
with each logger or available as a download at electromotive.com website. A drive
parameter set can be downloaded into a drive of same software version, model,
control method (flux vector, open loop vector or V/F) and motion. Caution should
be taken when downloading parameters into a flux vector drive. An autotune
should be performed even if the motors seemingly are identical to ensure peak
performance.
GETTING CONNECTED
The Datalogger supports all software versions for Series 3 drives and the
following software versions for Series 2 drives: 14906, 14908, 14909, 14911,