Filter
Top Products
Getting Started with Base Only Systems 11 000001630
MaxAttach NAS 6000 Getting Started
Getting Started with Base Only Systems
13: Modifying Default Network Settings in Non-DHCP Service
10/16/01 -- Revision 2.0.03
2. If a DHCP server is not running on your network, or you want to manually assign
the IP address, skip ahead to Step #13 - Modifying Default Network Settings in
Non-DHCP Service on page 11 below.
NOTE
Network and server administration best practices recommend assigning a fixed IP
address to a Maxtor MaxAttach NAS 6000.
13: Modifying Default Network Settings in Non-DHCP
Service
If your MaxAttach NAS 6000 is attached to a network without a DHCP server, or you
want to manually assign your IP address, your MaxAttach will be displayed with an IP
Address in the 169.254.XXX.XXX range. You must now assign a unique “Static IP
Address” to your unit.
1. See your network administrator for an available IP address before proceeding.
2. To set an IP address, highlight the default name of your MaxAttach with a single
mouse click and then select the Change Settings button.
3. You will receive a warning message about making changes. Click OK to clear it.
n The NAS Change Settings screen appears.
Figure #4 Network
Configuration
Warning Message