Filter
Top Products
2
Unpacking, installing, and setting up the printer
2-12
Connecting the power cable
Only use the power cable supplied with the printer!
The laser printer requires a power supply with minimal voltage and
frequency fluctuation. If necessary, ask an electrician for advice.
✔ Power supply: 120-1 27V at 50- 60Hz / 220- 240V at 50 -60Hz
✔ Voltage fluctuation: 1 20V -10%, 127V +6% / 2 20-240V ± 10
✔ Frequency fluctuation: Within 3 Hz
1
Make sure that the printer’s power
switch is in the “0” (OFF) position.
2
Insert the plug on the end of the
power cable (supplied) into the
power socket of the printer.
3
Insert the other end of the power
cable into a power socket.
CAUTION
Using the wrong power cable may cause a short-circuit!
Using power cables of inadequate cross-section can lead to overheating
of the cable.
Ü Only use an extension cable which has a higher rating than the current
consumption of the printer.
Ü Only use cables with a ground connection.
Ü Always observe the relevant local regulations regarding the
connection of electrical equipment to the main power.