Filter
Top Products
DiMAGE Scan Multi PRO 15
CONNECTING THE HARDWARE
Switch No. Function ON OFF
1 SCSI terminator ON OFF
2 Auto Power Save ON OFF
3———
4 Select Interface SCSI IEEE 1394
SETTING THE DIP SWITCHES
Before connecting the scanner to a computer turn off the power of the scanner, then, decide
which interface you will be using, and use the Dip switch No. 4 to set the scanner to the selected
interface. Set additional Dip switches for termination and auto power save if necessary.
Switch No. 1: SCSI Terminator
Set when selecting SCSI as the interface to be used to connect the scanner to a computer. If this
scanner is the last device of the SCSI chain, set to ON. Switch No. 1 is factory preset to ON.
Switch No. 2: Auto Power Save
Set to “ON” (up), if you want the fluorescent light to turn off automatically, when you are not going
to use it for about 2 hours. In order to save electricity and the life of the fluorescent light, we
recommend that you have it “ON”. The default setting is ON.
Switch No. 3: Inactive
Switch No. 4: Selecting an Interface
The selected interface can be switched between SCSI and IEEE 1394 when the scanner is
connected to a computer. The SCSI and IEEE 1394 cannot be used simultaneously. Switch No. 4
is factory preset to SCSI.