Filter
Top Products
DiMAGE Scan Multi PRO 37
LOADING THE FILM HOLDER
Removing a Film
While sliding the button on the cover of the
attachment, lift the film cover.
Removing an Attachment
1. While sliding the button on the cover of the
attachment, open the cover, and while sliding
the lever on the upper part of the holder to the
right, lift the cover and remove the pins.
2. While sliding the lever on the middle part of
the holder to the right, lift the attachment.
5. Place a film on the mask with the
emulsion side down while
aligning it carefully with the
cutout in the mask.
6. Close the film cover of the holder
until it clicks.
NOTE:
• Be sure to insert the appropriate mask
before inserting a film when scanning.
Otherwise, interference fringes with
concentric circles-patterns may appear
on the image after the scanning is
performed.