Filter
Top Products
DiMAGE Scan Multi PRO 33
120/220 (6x4.5, 6x6, 6x7, 6x8, 6x9) film attachment
with glass (HA-P1)
1. Install the selected attachment on
the holder.
Place the attachment with the button
side up at the position on the holder
that is suited for the attachment you
selected and fix it aligning with the two
grooves on the left side until it clicks.
If the 120/220 film attachment with
glassless (HA-P2) or the multi-format
attachment (HA-P3) is installed, remove
it beforehand.
2. Press the button on the attachment to open the
film cover.
Before inserting a film, remove dust, etc. from the film,
holder, attachment or mask using a blower brush, etc.
3. Insert the appropriate mask for the size of the
film.
Align the mask with the attachment. Fix the two protruding
parts into the slots on the hinge side Fit the mask over the
film guide and the two pins.
LOADING THE UNIVERSAL HOLDER UH-P1
The universal holder UH-P1 is used with the following
attachments. Use the attachment suited to the film.
• 120/220 film attachment with glass (HA-P1), glassless
(HA-P2)
When scanning 120/220 (6x4.5, 6x6, 6x7, 6x8, 6x9) film
Select a film attachment with glass or a glassless film
attachment according to your purpose.
With glass: When the film needs to be protected or kep flat.
Glassless: When you wish to avoid effects which may be
caused by the glass, for example, if you want to stay clear of
dust or dirt on the glass when scanning.
• Multi-format attachment (sold separately, HA-P3)
When scanning a TEM film, 35 mm panorama film, 16 mm
film, 4x4 or 24x24 film, etc.
LOADING THE FILM HOLDER