Filter
Top Products
EN-28
Installation other device’s remote
commands
You can install other device’s remote commands in the
remote control of this projector.
How to install
1. Set the SELECT switch of the remote control of this
projector to DVD or VIDEO, depending on the device
you use.
2. Place the remote control of this projector and that of
the other device with their transmission windows 2-5
cm apart.
2 - 5cm
Advanced features (continued)
3. Press the MEMORY button.
• The MEMORY button will blink red.
• To cancel the installation, press the MEMORY
button again.
4. Press any programmable button on the remote control
of this projector.
• The MEMORY button will stop blinking and stay
on.
• When no button is pressed for 6 seconds after step
3 and 4, the MEMORY button will go out
automatically.
5. Hold down the button on the other device’s remote
control whose command you want to install until the
MEMORY button start blinking.
• When the MEMORY button blinks six times and
then goes out, the function has been installed
successfully.
• When the MEMORY button doesn’t blink before
going out, the installation has failed.
• To continue to install other functions, repeat step 3
to 5.
• Some special commands are not memorized,
depending on the type of the remote control.
• Do not install any remote commands of other devices
including air conditioners than video devices.
How to use the installed functions
1. Set the SELECT switch of the remote control of this
projector to DVD or VIDEO, depending on the device
you use.
2. Press the programmable button in which the desired
remote command has been installed.
Programmable buttons
MEMORY button
SELECT switch