Mitsubishi Electronics XD700U Projector User Manual


  Open as PDF
of 61
 
EN-50
Connection
For details of the connection, see “LAN control UTILITY operation manual” in the CD-ROM.
When Standby Mode of the Efficient Mode menu in the Installation menu of the projector is set to Low, the LAN
network is disabled. To enable the LAN network, set Standby Mode to LAN. (See page 27.)
Configure the initial network settings first.
Youcanconguretheinitialsettingsusingtheprojectormenu(seepages34to38)orProjectorViewGlobal+.For
detailsofProjectorViewGlobal+,see“LANcontrolUTILITYoperationmanual”intheCD-ROM.
Using the User Manual
The User Manual for LAN Control Utility is prepared in the Portable Document Format (PDF) in the CD-ROM.
Opening the User Manual:
1. Load the CD-ROM into the CD-ROM drive.
2. Open CD-ROM “PROJECTOR.”
3. Double-click on “MANUAL_LAN.HTML” within the CD-ROM. A language selection list for the User Manual will be
displayed.
4. Move the mouse pointer to the desired language and click.
PJLink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command Description Remark (Parameter)
POWR Power control 0=Standby
1 = Power on
POWR? Inquiry about the power state
0=Standby
1 = Power on
2 = Cooling down
3 = Warming up
INPT Input switching 11 = Computer1 12 = Computer2
21 = Video 22 = S-Video
31 = HDMI
41 = PC Less Presentation 42 = USB Display
51 = LAN Display
INPT? Inquiry about input switching
AVMT Mute control 30=Videoandaudiomutedisable
31 = Video and audio mute enable
AVMT? Inquiry about the mute state
ERST? Inquiry about the error state 1stbyte:Fanerror,0or2
2ndbyte:Lamperror,0to2
3rdbyte:Temperatureerror,0or2
4thbyte:Coveropenerror,0or2
5thbyte:Always0
6thbyte:Othererror,0or2
0to2meanasfollows:
0=Noerrordetected,1=Warning,2=Error
LAMP? Inquiry about the lamp state
1st value (1 to 5 digits): Cumulative lamp operating time (This item shows
a lamp operating time (hour) calculated based on
that Lamp Mode is Low.)
2ndvalue:0=Lampoff,1=Lampon
INST? Inquiry about the available inputs The following value is returned.
“11 12 21 22 31 41 42 51”
NAME? Inquiry about the projector name The projector name set on the Network Config menu or the Crestron
RoomView Setup window is returned.
INF1? Inquiry about the manufacturer name “MITSUBISHI” is returned.
INF2? Inquiry about the model name “XD700U”or“WD720U”isreturned.
INF0? Inquiry about other information No other information is available. No parameter is returned.
CLSS? Inquiry about the class information “1” is returned.
• This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the commands defined by
PJLink™Class1,andthecompliancehasbeenveriedwiththePJLink™standardspecicationsVersion1.0.
Advanced features (continued)
 previous next