Filter
Top Products
CiM-550 IP Enabled Satellite Modem Rev. 2
SNMP interface CD/CIM550.IOM
240
13.4.2.4.2 ARP Configuration Subgroup
Table 13-29. ARP Configuration Subgroup OIDs
OID
Description
cimFlushArpTable
Can be used to flush the non-static ARP table.
The cimArpTable is used to configure the static ARP table. This table allows up to 256
static ARP entries. The Static ARP entries provided by the CiM-550 fall into two
categories: IP-to-MAC and IP-to-HDLC.
Note: For the CiM-550 to properly route packets over the Satellite Interface, all of the Next Hop
Addresses in the route table MUST have an IP-to-HDLC mapping in the static ARP table.
Incoming packets that match a route in the route table that does not have an IP-to-HDLC
mapping in the static ARP table will be discarded.
Table 13-30. CiM ARP Table OIDs
OID
Description
cimArpIndex
Sequential number that corresponds to the row index in the
ARP table. The ARP entry index starts at 1.
cimArpIpAddress
Used as a lookup into the ARP table when the CiM-550
needs to resolve a MAC or HDLC Address. The IP Address
must be on the same subnet as the Ethernet or Satellite
Interfaces. It must not map to multiple HDLC or MAC
addresses. The IP Address must be a valid Unicast address.
cimArpPhysAddress
This can either be a MAC address or a HDLC address. Valid
MAC addresses are in the form “xx:xx:xx:xx:xx:xx”, where “x”
represents any HEX number. Valid HDLC addresses are
number from 1 to 65534 that represent HEX numbers
between 1 – FFFE.
cimArpPhysType
Indicates if the ARP entry is an IP-to-MAC or an IP-to-HDLC
translation.
This OID can be set to:
1 IP To MAC
2 IP To HDLC