Filter
Top Products
CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
69
Parameter
Type
Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
define the unit as being an EDMAC Master.
This command is only valid for an EDMAC master.
When used as a Query, it may be sent to an
EDMAC slave, which will respond with the
appropriate address.
Circuit ID
string
CID= 24 bytes,
ASCII
Command or Query.
Sets or queries the user-defined Circuit ID string,
which is a fixed length of 24 characters.
Valid characters include:
Space ( ) * + - , . / 0-9 and A-Z.
CID= (message ok)
CID? (received ok,
but invalid arguments found)
CID? CID=xxxxxxxx
xxxxxxxxxxxxxx
x (same format
as command
arguments)
Outdoor Unit
Comms
ODU= 1 byte, value of
0 or 1
Command or Query.
Enables or disables communication, via an FSK
serial link, with a Comtech Transceiver (Outdoor
unit).
0 = disabled
1 = enabled
Example: ODU=0
ODU= (message ok)
ODU? (received ok,
but invalid arguments found)
ODU* (message ok, but not
permitted in current mode)
ODU? ODU=x
(same format as
command
arguments)
AUPC
Enable
AUP= 1 byte, value of
0 or 1
Command or Query.
Enables or disables AUPC (Automatic Uplink
Power Control). 0 = disabled 1 = enabled
Example: APC=0
Note: Framing must be selected for the AUPC
feature to work. If AUPC is selected when Framing
is disabled, APC* will be returned
AUP= (message ok)
AUP? (received ok,
but invalid arguments found)
AUP* (message ok, but not
permitted in current mode)
AUP? AUP=x
(same format as
command
arguments)
AUPC
Parameters
APP= 6 bytes, Command or Query.
Defines AUPC (Automatic Uplink Power Control)
operating parameters. Has the form abc.cd
Where:
a = Define action on max power condition:
APP= (message ok)
APP? (received ok,
but invalid arguments found)
APP* (message ok, but not
permitted in current mode)
APP? APP=abc.cd
(same format as
command
arguments)