Filter
Top Products
CX-MB-EVA2 User's Manual Hardware
28
4.8 TV Out
A TV-OUT connector is implemented for displaying the video signal on a TV set (or the
like). The base board supports the following video signals
Composite Video
Component Video (YPbPr)
S-Video
The type of the video signal is defined by the graphics controller on the COM Express
module.
Specification:
References: X17
Connector: AMP 5786766-1
Pinout: Refer to Table 6
Pin Signal name Composite Component S-Video
1 TV_IRTN_B Ground Ground Ground
2 TV_IRTN_C Ground Ground Ground
3 TV_DACB not used Luminance (Y) Luminance
4 TV_DACC not used Chrominance (Pr) Chrominance
5 TV_DACA CVBS Chrominance (Pb) not used
6 TV_IRTNA Ground Ground Ground
7 RSVD reserved reserved reserved
Table 11 Pinout TV-Out
The signals can be adapted to a different interface with a 10-pin header.
Specification:
References: X53
Connector: IDC-M 10pol. THT RM2.54
Pinout: Refer to Table 7
Pin Signal Pin Signal
1 GND 2 TV_DACA
3 GND 4 TV_DACB
5 GND 6 TV_DACC
7 GND 8 GND
9 GND 10 GND
Table 12 Pinout TV-Out Pin header