Filter
Top Products
33
Chapter 4 - Firewall Software
The WAN Port Parameters group is used to configure the WAN port, if enabled. The WAN port
parameters are established when the ProxyServer is directly connected to the Internet via the
RS232/V.35 connector on the back of the unit.
ISP Assigns Dynamic Address - Normally, the ISP assigns a dynamic address when the
port comes up. If this is not the case, disable this option and assign a valid registered Internet
address in the IP Address field.
IP Address - If dynamic addressing is enabled, this field is dynamically assigned by
the ISP. If static addressing is enabled, enter a valid Internet address in this field.
Net Mask - Enter the Subnetwork Mask for the WAN port in this field.
The Internet Gateway Parameters group is used to configure the Internet gateway if used by
the Internet LAN (LAN 2) port.
WAN - If a connection to the Internet Services Network is provided via a DCE device
connected to the RS232/V.35 port on the back of the ProxyServer, then this option must be
selected.
Internet LAN - If a connection to the Internet Services Network is provided through the
Internet LAN (LAN 2), then this option must be selected. If the Internet LAN is configured as
a DHCP Client, then the IP address will be dynamically assigned by the ISP. If the DHCP
Client option is disabled, then a valid registered Internet address must be entered in the IP
Address field.
IP Address - If the Internet LAN is configured as a DHCP Client, this address will be
dynamically assigned by the ISP. If the DHCP Client option is disabled, the a valid
registered Internet address must be entered in the IP Address field.