Filter
Top Products
2 - 8
TM
CHAP. 2
INSTA…
(3.0" SPACER)
(2.25" SPACER)
Fig. 8 Putting spacer to roll paper shaft Fig. 9 Finish paper loading
Removing The Roll Paper
Remove the top cover then cut off the paper near the rear of the paper
guide and press the FEED switch to feed out the paper remaining in the unit.
When the paper runs out, a buzzer will sound 4 times per cycle for 2 cycles.
Note 1. Remove the paper remaining in the printer by pressing the FEED switch
(If you remove the paper by hand, the paper could be wrinkled or slip
and cause a paper jam).
2. When the paper end mark appears on the paper, replace the roll paper
before it runs out.
Insert paper through
the paper cut slot
behind the tear bar