Filter
Top Products
12. REFERENCE
12-1. Attaching an Arm Stand
The eClient 630LT-GR/630LT-GR-N can be used with an arm stand by removing the tilt
stand and attaching the arm stand to the terminal.
NOTE
• Use an arm stand that satisfies the following.
- When using the eClient 630LT-GR/630LT-GR-N with an arm stand, the arm stand
must be VESA approved:
- Use an arm stand with a 75 mm x 75 mm hole spacing on the arm mounting pad.
- Use an arm stand that is able to support an object weighing 8.0 kg.
- A GS approved arm stand.
- Use an arm stand with sufficient stability (mechanical firmness) to support the
weight of the monitor.
- Use an arm stand remaining that position where it is manually moved.
- Use an arm stand with the ability to tilt the monitor forward and backward.
• Please connect cables after attaching an arm stand.
Setup Procedure
1.
Lay the eClient 630LT-GR/630LT-GR-N down as shown below. Do
not scratch the panel.
2.
Remove the stand by loosening the screws (M4 x 16 mm).
3.
Attach an arm stand to the eClient 630LT-GR/630LT-GR-N securely.
(1)
(2)
(3)
(4)
Arm
(1), (2), (3), (4): Enclosed Screws, M4 x 12 mm
12. REFERENCE
67