Eizo RX211 Network Router User Manual


 
8
Notice for this monitor
Notice for this monitor
• This product is suited to display medical images of such modalities as MRI and CT. It does
not support the display of mammography images for diagnosis.
• This product has been adjusted specifically for use in the region to which it was originally
shipped. If the product is used outside the region, it may not operate as specified in the
specifications.
• This product may not be covered by warranty for uses other than those described in this
manual.
• The specifications noted in this manual are only applicable for power cords and signal cables
specified by us.
• Use optional products manufactured or specified by us with this product.
• As it takes about 30 minutes for the performance of electrical parts to stabilize, adjust the
monitor 30 minutes or more after the monitor power has been turned on.
• When the screen image is changed after displaying the same image for extended periods of
time, an afterimage may appear. Use the screen saver or timer to avoid displaying the same
image for extended periods of time.
• Periodic cleaning is recommended to keep the monitor looking new and to prolong its
operation lifetime. (Refer to "Cleaning" on the next page.)
• The screen may have defective pixels. These pixels may appear as slightly light or dark area
on the screen. This is due to the characteristics of the panel itself, and not the product.
• The backlight of the LCD panel has a fixed life span. When the screen becomes dark or
begins to flicker, please contact your dealer.
• Do not press on the panel or edge of the frame strongly, as this may result in the display
malfunction, such as the interference patterns, etc. If pressure is continually applied to the
LCD panel, it may deteriorate or damage your LCD panel. (If the pressure marks remain on
the LCD panel, leave the monitor with a white or black screen. The symptom may disappear.)
• Do not scratch or press on the panel with any sharp objects, such as a pencil or pen as this
may result in damage to the panel. Do not attempt to brush with tissues as this may scratch
the LCD panel.
• When the monitor is cold and brought into a room or the room temperature goes up quickly,
dew condensation may occur inside and outside the monitor. In that case, do not turn the
monitor on and wait until dew condensation disappears, otherwise it may cause some
damages to the monitor.