Filter
Top Products
2. Cable Connection and Screen Adjustment
17
2-3. Connecting Two PCs to the Monitor
Two PCs can be connected to the monitor through the Signal 1 and the Signal 2 on the
back of the monitor.
Selecting the Active Input
The Input Signal Selection Switch on the control panel can be used to select either Signal 1
or Signal 2 as the active input at any time. Every time the Switch is touched, the input
changes. When the signal is switched, the active signal type (Signal 1 or 2/ Analog or
Digital) appears at the top right corner of the screen.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor by
selecting <Input Priority> in the ScreenManager <Setup> menu (See p. 23 to use the
ScreenManager).
In the case of only one signal being present at either input, the monitor
automatically detects and displays that signal.
Priority Setting Performance
1
(DVI-D Connector)
The monitor gives preference to Signal 2 in the following cases.·
•
When the power of the monitor is turned ON
•
When the signal input to Signal 1 is changed even if active input
was Signal 2
2
(D-Sub mini 15 pin Connector)
The monitor gives preference to Signal 2 in the following cases.·
•
When the power of the monitor is turned ON
•
When the signal input to Signal 2 is changed even if active input
was Signal 1
Manual The monitor will not detect signals automatically in this mode.
Select the active input by pressing the Input Signal Selection
Switch on the monitor’s control panel.
Tips
• When the “1” or “2” is selected, the power saving mode of the monitor activates only if
both PCs are in power saving mode.
SIGNAL1
DVI-D
SIGNAL2
D-Sub mini 15
Input Signal Selection Switch
English