Filter
Top Products
6. Attaching an Arm
35
6. Attaching an Arm
The LCD monitor can be used with an arm by removing the tilt stand and attaching the
arm stand to the LCD monitor.
NOTE
•
If you will use the arm or stand of other manufacturers, confirm the followings to the
manufacturers before selecting.
-
Hole spacing on the arm mounting
100 mm x 100 mm (VESA compliant)
-
Supportable Weight: Total weight of the monitor (without stand) and attaching
equipment such as a cable
-
TÜV/GS approved arm or stand
•
Please connect cables after attaching an arm stand.
Setup Procedure
1
Hold the upper and lower centers of the stand joint cover, and slide
sideways to remove it.
2
Lay the LCD monitor on a soft cloth spread over on a stable surface
with the panel surface facing down.
3
Remove the stand. (Prepare a screwdriver.)
Unscrew the two screws securing the unit and the stand with the screwdriver.
4
Attach the monitor to the arm or stand.
Secure the stand to the monitor with four screws using a screwdriver.
Stand mounting cover
arm
English