National Instruments NI-488.2 Time Clock User Manual


 
Chapter 8 wibconf-Windows Interface Bus Configuration Utility
© National Instruments Corp. 8-15 NI-488.2 User Manual for Windows
Table 8-2. wibconf Batch Mode Command Pairs
First Item
Mnemonic Explanation
Second Item
find
Find board or device board# or device #
pad
Primary GPIB address number
sad
Secondary GPIB address number
tmo
Timeout settings mnemonic
xeos
Set EOI with EOS on write yes or no
bin
Type of compare on EOS 7-bit or 8-bit
eot
Set EOI with last byte of write yes or no
sc
System Controller (board only) yes or no
sre
Assert REN when SC (board only) yes or no
spoll
Enable auto serial polling (board only) yes or no
tmng
Timing (board only) 2msec, 500nsec, or
350nsec
cic
_
prot
CIC protocol (board only) yes or no
int
Interrupt setting (board only) number
port
Base I/O address (board only) number
dma
DMA channel (board only) number
raddr
Repeat addressing (device only) yes or no
name
Rename a device (device only) device name
connect
Connect a device to a board (device only) board#
disconnect
Disconnect a device from a board (device
only)
no value
type
Switch the current board to PCII or PCIIA
mode
PCII or PCIIA
pplength
Parallel poll duration (board only) mnemonic
useboard
Use this interface board (board only) yes or no
spolltmo
Serial Poll Timeout (device only) mnemonic