Filter
Top Products
Chapter 4 PCMCIA Serial Hardware Installation, Verification, and Configuration
Serial Hardware and Software for Windows 4-20 ni.com
5. Click on Delete to remove hardware information about the port from
Windows NT. You should do this before you physically remove your
PCMCIA card.
6. Click on Add to configure resources for a new PCMCIA card.
General Port Settings
This section describes the options you can setin the General Port Settings
dialog box, shown in Figure 4-11.
Figure 4-11. General Port Settings Dialog Box
COM Port Number
You can use the COM Port Number control to change the COMx name of
the port selected.
Transceiver Mode
The transceiver mode selection shows the transceiver mode in use, and
applies only to PCMCIA-485 cards. Refer to Chapter 6, Using Your Serial
Hardware, for more information about transceiver modes. If you use
two-wire TXRDY
mode, FIFOs must be enabled.