NEC MT840 Projector User Manual


 
E–34
2. Remove both old batteries and install new ones (AA). Ensure that
you have the batteries' polarity (+/–) aligned correctly.
3. Slip the cover back over the batteries until it snaps into place.
Remote Control Battery Installation
1. Press firmly and slide the battery cover off.
M
E
N
U
OU
RCE AUTO ADJUST
USB
AC IN
Cleaning or Replacing the Filters
The air-filter sponge keeps the inside of the MultiSync MT840/
MT1040/MT1045 Projector free from dust or dirt and should be
cleaned after every 100 hours of operation (more often in dusty con-
ditions). If the filter is dirty or clogged, your projector may overheat.
CAUTION
Turn off the power and unplug the projector before re-
placing the filter.
Only clean the outside of the filter cover with a vacuum
cleaner.
Do not attempt to operate the projector without a filter
cover.
Your projector will not operate unless the filter cover is
installed correctly.
To clean the air-filter:
Vacuum the filter-through the filter cover.
AC IN
1
2
M
E
N
U
E
L
EC
T
SOURCE AUTO ADJUST
USB
AC IN
1
2
To replace the air-filter:
1. Remove the filter cover by pushing up on the catch of the cover
until you feel it detach.
2. Reinstall the new filter cover.
NOTE: Do not detach the sponge from the filter cover. Do not wash
the filter cover with soap and water. Soap and water will damage the
the filter membrane. Before replacing the filter cover, remove dust
and dirt from the projector cabinet. Keep out dust and during filter
replacement.