Filter
Top Products
25
3. Projecting an Image (Basic Operation)
A
U
T
3
D
R
E
FO
R
M
1
2
Adjusting the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment
as it can become heated while the projector is turned on and during
its cool down period after it is turned off.
2.
Push up the Adjustable Tilt Foot Lever on the front of the projector
to extend the adjustable tilt feet (maximum height).
3. Lower the front of the projector to the desired height.
4.
Release the Adjustable Tilt Foot lever to lock the Adjustable tilt foot.
There is approximately 10 degrees (up) of adjustment for the front of
the projector.
TIP: For operating the [KEYSTONE] screen, see “❹ Correcting Keystone Dis-
tortion” on page
26.
NOTE: Your “Keystone” correction data can be reset by pressing and holding
the 3D REFORM button for a minimum of 2 seconds.
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
The rear foot height can be adjusted up to 0.5 inch/13 mm.
Rotate the rear foot to the desired height in order to square the image on
the projection surface, but the vertical distance from the bottom to the
desk or oor should be 0.5 inch /13mm to make the projector horizontal
on the at surface.
Adjustable Tilt
Foot Lever
U
SB
L
A
MP
S
T
A
T
U
S
S
O
U
R
C
E
A
U
T
O
A
D
J
U
S
T
3
D
R
E
F
O
R
M
S
E
L
E
CT
4
3
Adjustable Tilt Foot