Filter
Top Products
4-40 Installing Options
IDE Connector Configuration
Configuration Primary connector Secondary connector
4 devices (hard drive, hard
drive, CD-ROM, LS-120
drive)
Master - hard drive
Slave - hard drive
Master - CD-ROM
Slave - LS-120 drive
4 devices (hard drive, hard
drive, Zip drive, tape
backup)
Master - hard drive
Slave - hard drive
Master - Zip drive
Slave - tape backup
4 devices (hard drive, hard
drive, Zip drive, LS-120
drive)
Master - hard drive
Slave - hard drive
Master - Zip drive
Slave - LS-120 drive
4 devices (hard drive, hard
drive, tape backup, LS-120
drive)
Master - hard drive
Slave - hard drive
Master - tape backup
Slave - LS-120 drive
4 devices* (hard drive,
LS-120 drive, CD-ROM, Zip
drive)
Master - hard drive
Slave - CD-ROM
Master - Zip drive
Slave - LS-120 drive
4 devices* (hard drive,
LS-120 drive, CD-ROM,
tape backup)
Master - hard drive
Slave - CD-ROM
Master - tape backup
Slave - LS-120 drive
4 devices* (hard drive,
LS-120 drive, Zip drive, tape
backup)
Master - hard drive
Slave - LS-120 drive
Master - Zip drive
Slave - tape backup
*
Hard drive must be mounted in top location
Diskette Drive Signal Cable
A diskette drive signal cable comes attached to the system
board and to the standard 1.44-MB diskette drive.
The colored edge of the cable goes to pin 1 on the cable
connector. Align the red edge of the cable with pin 1 (the
notched end) on the drive connector.