Filter
Top Products
Installing Options 4-47
5. Remove the blank plastic panel from the bay by pressing
the panel tabs from inside the front panel and pushing the
blank panel out.
Save the panel for future use if you remove a device and
don’t replace it (see “Replacing the Front Panel” for
procedures to reinstall the plastic panel).
Locating the blank panel tabs
A
– Blank Panel Tabs
6. Remove the metal shield from the bay where you are
installing the device (see the figure “Removing the front
panel” for shield location).
Insert a screwdriver into one of the holes in the metal
shield.
Twist the shield with the screwdriver until it comes
loose.
7. Install the device (see “Installing a 5 1/4-Inch Device”
later in this chapter).