Filter
Top Products
3-36 Configuring the System
You forgot your password and need to clear it.
You need to restore the CMOS settings to the factory state.
Your BIOS is corrupted and you must perform a BIOS
Recovery. This is performed with a BIOS Recovery
diskette and is seldom required. If it is, contact NEC CSD
Technical Support for assistance (see Section 6 for
information on contacting Technical Support).
You can obtain the BIOS Recovery program by
downloading it to a diskette from the NEC CSD Bulletin
Board System (BBS), the NEC CSD File Transfer
Protocol (FTP) site, or the NEC CSD website. See
Chapter 6 for information on downloading.
The following figure shows system board jumpers.
Locating system board jumpers
A
– Power On Mode Jumper JP1
C
– Clear CMOS Jumper JBAT1
B
– Processor/Bus Speed Jumpers SW1