Filter
Top Products
iTap GigaBit Dual Port Aggregator
11
To change the username and password:
1. Change the username by typing the following command:
set username <username>
where <username> is your new username.
2. Change the password by typing the following command:
set password <password>
where <password> is your new password.
3. Record the username and password in a secure location.
To set the iTap IP address:
1. Type set ip <ip address> where <ip address> is the IP address you are assign-
ing to the iTap and press Enter.
For example, typing set ip 10.60.0.100 sets the iTap IP address to 10.60.0.100.
To set the utilization threshold levels:
1. Type set threshold port a <level> where <level> is the percentage of the
available bandwidth at which the utilization alarm for Port A is triggered. Press
Enter.
For example, typing set threshold port a 30 sets the alarm threshold level for
traffi c received on Port A to 30%.
2. Type set threshold port b <level> where <level> is the percentage of the
available bandwidth at which the utilization alarm for Port B is triggered. Press
Enter.
For example, typing set threshold port b 30 sets the alarm threshold level for
traffi c received on Port B to 30%.
Tip! _____________________________________________________________________
You can set the utilization threshold levels at any time from the remote interfaces.
See Chapters 4 and 5 for more information.
__________________________________________________________________________