Filter
Top Products
iTap GigaBit Dual Port Aggregator
14
Connecting the Management Port
To use the remote interfaces you must connect the Management Port to the
network.
To connect the iTap Management Port:
1. Connect a CAT5 cable to the Manangement Port as shown in Figure 9.
2. Connect the other end to a network switch or hub.
Figure 9: Connecting the Management Port
Connecting to the Network
The iTap comes with two network cables ready for iTap installation.
To connect the iTap to your network:
1. Connect Network Port A to the appropriate network device using the cables
supplied with your iTap.
2. Connect Network Port B to the appropriate network device using the cables
supplied with your iTap.
3. Verify that the iTap Network Ports are cabled in-line between two devices.
Management
Port
RS232
To network switch or hub